Well I did this mod yesterday and then eventually taking the doors off because I knew it would be nice out. The next day (today) I'm all ready to go, get in the Jeep and the sonoab wont fire. I have power, all the lights come on. I hear about two clicks from under the hood and that's it. Could this be from the lights being re-wired. I know I didn't do it wrong because they were working last night. Any info would help

 

Make sure you have a good connection on your battery. Also, it might be dead. You might have routed a continuous positive wire to the ground and drained battery.

 

I am thinking just a dead battery. Wiring should be fine. Make sure you don't have you cabin lights set to always on.

 

Cabin lights turn off after several minutes.

 

Wife came home, jumped the jeep and it started. Check engine light is still on.

 

what a great idea. I'm going to do this, this weekend!

 

I just performed the turn signal mod tonight. Here is a short 2 minute video I made after the fact to help eleviate some of the confusion between how they work, when they work, and when they don't work. Hope it helps...


http://youtu.be/oArVRDAdMIc

 

Has anyone made a video of the actual cutting and splicing of the wires ????

 

I didn't make this, just found it on youtube. Word of caution, the comments under the video mention this mod is for a 2013 Wrangler, viewer comments say this will not work on the 2014 Wrangler.


http://www.youtube.com/watch?v=1bcXueAXphs

 

I believe those comments are wrong, I have seen others do this mod in a 2014.